Sigma Engineered Solutions ProConnex 1/2 in. D Die-Cast Zinc Pull Elbow For Rigid/IMC 1 pk

Item No. 30464 30464

Sigma Engineered Solutions ProConnex 1/2 in. D Die-Cast Zinc Pull Elbow For Rigid/IMC 1 pk

Item No. 30464 30464
$3.99

3 in stock at Sulphur

FREE Store Pickup

Available for Pickup Today!

Selected Store

Ship to Home

  • Shipping is available for this item.


Sigma's Rigid to Rigid pull elbows are used to facilitate pulling conductors through a 90-degree bend between two runs of threaded Rigid conduit or IMC. The removable cover provides ample access so that wire pulling can be achived without obstructions. These die-cast connectors are preassembled with cover and gasket.
  • Rigid-to-rigid pull elbows are used to facilitate pulling conductors through a 90 degree bend between two runs of threaded 1/2-in Rigid conduit or IMC
  • Changes direction of raceways by 90
  • Pre-assembled with a removable stamped aluminum cover and rubber gasket
  • Zinc die-cast construction with stamped aluminum cover and rubber gasket
  • Product is UL and CSA listed
  • ProConnex
  • 1
  • 30464
  • Pull Elbow
  • N
  • ProConnex
  • Sigma Engineered Solutions
  • Sigma Engineered Solutions
  • Yes
  • Rigid/IMC
  • 1/2 inch
  • Die Cast Zinc
  • 1 pack
  • Bagged
  • ProConnex
  • Yes

You May Also Like